Csdrhrt

I am trying to figure out a way to run a shell script B from script A, set or export a variable in script B, and be able to store that value in script A after script B finishes and its sub-shell returns.

I'm not trying to source script B. I only want 1 specific variable. I can add stuff to script A, but I don't want any variables possibly set in script B to overwrite anything in script A besides what I am specifically trying to capture.

I'm sure there are some ugly ways, like writing out all the variables I care about in A to a file, source script B, then read everything back in from the file and restore the variables in A, besides the variable set in B that I want. I'm looking for a relatively clean and straightforward way, if one exists.

This other answer is good, it should be your first choice, especially if your B script does one thing and does it well (see Unix philosophy) and this "one thing" means "computing this particular variable value".

But what if the main purpose of B is to print something else? or even interact with the user? Passing additional data via stdout requires additional parsing of the retrieved result. If so, a totally independent channel of communication between B and A is highly desired. In your case one way communication is sufficient.

A temporary file is in fact quite good for it. But when you say

ugly ways, like writing out all the variables I care about in A to a file, source script B, then read everything back in from the file and restore the variables in A, besides the variable set in B that I want

you're turning the situation upside down and it's indeed ugly. The right way is to use a file to pass this one desired variable only.

In A:

tmpf_foo=$(mktemp)

Then you call B with "$tmpf_foo" as a command line argument and refer to the file by "$1" in B (or by another number, depending on the design). This may not be convenient if B already parses its command line arguments.

An alternative way is to export tmpf_foo in A and refer to the file as "$tmpf_foo" in B.

If B is a general purpose tool that can be used not only from within A, it's good to check (in B) if the file exists, before you write to it (e.g. if [ -f "$tmpf_foo" ]; then …).

Anyway, in B you write your desired value to the file. E.g. the file content will be:

12345

After B successfully finishes, in A you retrieve the value like this:

specificvariable=$(<"$tmpf_foo")

(equivalent to specificvariable=$(cat "$tmpf_foo") but without cat; not portable though).

If you need to pass more than one variable from B to A, you may use multiple lines and read them (in A) with read. But if you don't know in advance which variable(s) should be altered (or if any at all), then make B create lines in the file so it looks like this:

specificvariable=12345

othervariable="xyz 0"

bar=baz

unset var1

After B successfully finishes, in A you source the file:

. "$tmpf_foo"

Note you may pass any command this way (in the above example unset is a command) and it will be executed from within A. For this reason you should be very careful while writing to the file from within B and you should make sure no other (rogue) process can inject strings to the file.

At the end (in A) you remove the temporary file with rm "$tmpf_foo".

Write that specific variable to stdout, then in A:

specificvariable=$(/path/to/B.sh)